ÖÐÎÄ         ENGLISH s-04 s-05
  STC  
   

Product>>8051 MicroController>>STC15F101E series


Features:

 

  • Enhanced 80C51 Central Processing Unit, faster 6~7 times than the rate of a traditional 8051.
  • Operating voltage range: 3.8 ~ 5.5V or 2.4V ~ 3.6V (STC15L101E series)
  • Operating frequency range: 5MHz ~ 35MHz, is equivalent to standard 8051: 60MHz ~ 420MHz
  • A high-precision internal RC oscillator with temperature drifting ¡À1% (-400C~+850C)
  • Internal RC oscillator with adjustable frequency to 5.5296MHz /11.0592MHz /22.1184MHz /33.1776MHz
  • On-chip 128 bytes RAM and 0.5K~6K bytes code flash with flexible ISP/IAP capability
  • EEPROM function
  • Code protection for flash memory access.
  • Two 16-bit timers/counters ¡ª Timer 0 / Timer 1 with mode 0 (16-bit auto-reload mode), mode 1 (16-bit timer mode) and mode 2 (8-bit auto-reload mode).
  • Simulate UART can be realized by P3.0,P3.1 and Timers
  • 8 interrupt sources
  • One 15 bits Watch-Dog-Timer with 8-bit pre-scalar (one-time-enabled)
  • Three power management modes: idle mode, slow down mode and power-down mode.
  • Power down mode can be woken-up by external INTx pin (INT0/P3.2, INT1/P3.3, INT2 , INT3, INT4 ).
  • Excellent noise immunity, very low power consumption
  • Support 2-wire serial flash programming interface.(GND/P3.0/P3.1/VCC)
  • Programmable clock output Function. T0 output the clock on P3.5, T1 output clock on P3.4.
  • 6 configurable I/O ports are available and default to quasi-bidirectional after reset. All ports may be independently configured to one of four modes : quasi-bidirectional, push-pull output, input-only or opendrain output.
  • The drive capability of each port is up to 20 mA. But recommend the whole chip's should be less than 70 mA.
  • Package type: SOP-8, PDIP8
  • All products are baked 8 hours in high-temperature 175°C after be packaged ,Manufacture guarantee good quality.
  • In Keil C development environment, select the Intel 8052 to compiling and only contain < reg51.h >

 

Product Documents:

General Overview: STC15F101E_Features.pdf

Data Sheet: STC15F101E.pdf

ROSH£º

Product Support:

ISP programming software £ºSTC ISP programming software (v6.88)

Sample & Buy£º

Sample£ºSample Request Form

Buy £ºBuy Online

 

STC15F101E series MCU Selection Table£º

 

ParNo Voltage
(V)
Flash
(Byte)
SRAM
(Byte)
T
I
M
E
R
D/A A/D
8 ch
PCA I/O W
D
T
Built
in
Reset
EEP
ROM
(Byte)
Internal low voltage interrupt Internal Reset threshold voltage can be configured External interrupts which can wake up power down mode Special timer for waking power down mode Package
8-Pin
6 I/O
Package
8-Pin
6 I/O
STC15F100 5.5 - 3.8 0.5K 128 2 N - N 6 Y Y N Y 8 5 N DIP SOP
STC15F101 5.5 - 3.8 1K 128 2 N - N 6 Y Y N Y 8 5 N DIP SOP
STC15F101E 5.5 - 3.8 2K 128 2 N - N 6 Y Y 2K Y 8 5 N DIP SOP
STC15F102 5.5 - 3.8 2K 128 2 N - N 6 Y Y N Y 8 5 N DIP SOP
STC15F102E 5.5 - 3.8 3K 128 2 N - N 6 Y Y 2K Y 8 5 N DIP SOP
STC15F103 5.5 - 3.8 3K 128 2 N - N 6 Y Y N Y 8 5 N DIP SOP
STC15F103E 5.5 - 3.8 4K 128 2 N - N 6 Y Y 2K Y 8 5 N DIP SOP
STC15F104 5.5 - 3.8 4K 128 2 N - N 6 Y Y N Y 8 5 N DIP SOP
STC15F104E 5.5 - 3.8 4K 128 2 N - N 6 Y Y 1K Y 8 5 N DIP SOP
STC15F105 5.5 - 3.8 5K 128 2 N - N 6 Y Y N Y 8 5 N DIP SOP
STC15F105E 5.5 - 3.8 5K 128 2 N - N 6 Y Y 1K Y 8 5 N DIP SOP
IAP15F106 5.5 - 3.8 6K 128 2 N - N 6 Y Y IAP Y 8 5 N DIP SOP
¡¡
STC15L100 3.6 - 2.4 0.5K 128 2 N - N 6 Y Y N Y 8 5 N DIP SOP
STC15L101 3.6 - 2.4 1K 128 2 N - N 6 Y Y N Y 8 5 N DIP SOP
STC15L101E 3.6 - 2.4 2K 128 2 N - N 6 Y Y 2K Y 8 5 N DIP SOP
STC15L102 3.6 - 2.4 2K 128 2 N - N 6 Y Y N Y 8 5 N DIP SOP
STC15L102E 3.6 - 2.4 3K 128 2 N - N 6 Y Y 2K Y 8 5 N DIP SOP
STC15L103 3.6 - 2.4 3K 128 2 N - N 6 Y Y N Y 8 5 N DIP SOP
STC15L103E 3.6 - 2.4 3K 128 2 N - N 6 Y Y 2K Y 8 5 N DIP SOP
STC15L104 3.6 - 2.4 4K 128 2 N - N 6 Y Y N Y 8 5 N DIP SOP
STC15L104E 3.6 - 2.4 4K 128 2 N - N 6 Y Y 1K Y 8 5 N DIP SOP
STC15L105 3.6 - 2.4 5K 128 2 N - N 6 Y Y N Y 8 5 N DIP SOP
STC15L105E 3.6 - 2.4 5K 128 2 N - N 6 Y Y 1K Y 8 5 N DIP SOP
IAP15L106 3.6 - 2.4 6K 128 2 N - N 6 Y Y IAP Y 8 5 N DIP SOP